Replacing A Pci Card; Figure 8-6 Removing And Replacing A Pci Card - Sun Microsystems Sun Blade 100 Service Manual

FIGURE 8-6
8.4.2

Replacing a PCI Card

Note – Read the PCI card product guide for information about jumper or switch
settings, slot requirements, and required tools.
1. Ensure that there is no back plate in the PCI slot that you intend to use.
2. Position the PCI card into the chassis (
3. Insert the PCI card connector so that it touches the associated riser board
connector.
4. Guide the PCI card bracket tab into the back panel slot of the chassis: ensure that
the card bracket tab fits under the retaining tab on the back of the chassis.
5. At the two corners of the card, push the card into the riser board connector until
the card is fully seated.
6. If you are installing a long PCI card, depress the detent and slide the retractable
card guide forward to secure the rear of the PCI card.
7. Position the PCI card bracket retainer onto the chassis.
PCI card bracket retainer
Removing and Replacing a PCI Card
Chapter 8 Removing and Replacing the Motherboard and Related Components
Detent
).
FIGURE 8-6
Retractable card guide
8-13