Table of Contents
Advertisement
Ensemble HPe 150/200
2.3.2. Hall-Effect Interface (J207)
The Hall-effect switch inputs are recommended for AC brushless motor commutation but not absolutely
required. The Hall-effect inputs accept 5-24 VDC level signals.
Refer to
Section 2.2.1.1.
Table 2-10:
Hall-Effect Feedback Interface Pin Assignment (J207)
Pin#
Description
1
Chassis Frame Ground
3
+5V Power for Encoder (500 mA max)
5
Hall-Effect Sensor B (brushless motors only)
10
Hall-Effect Sensor A (brushless motors only)
11
Hall-Effect Sensor C (brushless motors only)
21
Signal Common for Encoder
+3.3V
74AC16244
36
for Hall-effect device phasing.
10K
10K
10K
Figure 2-19:
Hall-Effect Inputs (J207)
Chapter 2
Installation and Configuration
+5V
In/Out/Bi
N/A
Output
Input
Input
Input
N/A
HA
J207-10
HB
J207-5
HC
J207-11
www.aerotech.com
Advertisement
Table of Contents
