Table of Contents
Advertisement
Ensemble HPe 150/200
2.3.6. Brake Output (J207)
The Brake Output pins provide a direct connection to either the solid state relay on the Ensemble
HPe 150/200 or the mechanical relay on the optional -IO board. The brake output pins in J207 permit the
brake to be wired with other signals in the feedback cable. The brake is configured for automatic or manual
control using controller parameters (refer to the Ensemble Help file for more information).
Use either the solid state relay on the Ensemble HPe 150/200 or the mechanical relay on the -IO board when
connecting a power supply to the brake outputs on J207. Do not use both relays at the same time.
Refer to
Section 2.6.
for more information on using the brake output with the solid-state relay.
Refer to
Section 3.1.
for more information on using the brake output with the mechanical relay.
Table 2-14:
Brake Output Pin Assignment (J207)
Pin#
Description
13
Optional Brake - Output
25
Optional Brake + Output
42
Installation and Configuration
Chapter 2
In/Out/Bi
Output
Output
www.aerotech.com
Advertisement
Table of Contents
