Table of Contents
Advertisement
Installation and Configuration
2.2.2. DC Brush Motor Connections
The configuration shown in
Section 2.2.2.1.
for information on motor phasing.
TB102
no connection
Table 2-5:
Wire Colors for Aerotech Supplied Cables (DC Brush)
Pin
Wire Color Set 1
Green & White & Shield
A
Red & Orange
C
Yellow & Blue
(1) Wire Color Set #1 is the typical Aerotech wire set used by Aerotech.
(2) "&" (Red & Orange) indicates two wires; " / " (Green/White) indicates a single wire
www.aerotech.com
Figure 2-8
is an example of a typical DC brush motor connection. Refer to
AC1
10.15
[0.4]
MOTOR
AC2
SUPPLY
240V~ MAX
50/60Hz
75A MAX
AC3
19 [.735]
Green & White & Shield
MOTOR
Red & Orange
OUTPUT
ECZ00285
A
USB
B
J208
Yellow & Blue
ECZ00285
C
B+
NOTES:
Listed wire colors are for Aerotech supplied cables.
B-
DC BUS
Install 1 bead per wire at drive (Aerotech P/N: ECZ00285)
Figure 2-8:
DC Brush Motor Configuration
(1)
Wire Color Set 2
(2)
Green/Yellow & Shield
Chapter 2
Ensemble HPe 150/200
Bead Dimensions:
MM [Inches]
50.8 [2.0]
Motor Frame
DC Brush
+
Green/Yellow & Shield
Red
Black
-
Motor
Wire Color Set 3
Red & Orange
Yellow & Blue
23
Advertisement
Table of Contents
