Pso Output Interface (Tb302) - Aerotech HPe 150 Hardware Manual

-IO Expansion Board

3.2. PSO Output Interface (TB302)

TB302 provides the open-collector PSO output. Jumper JP2 defines the active state of the open-collector
output (defined in Table
voltage, and current requirements. An external power supply is required for the PSOOPTO1/2 options.
Table 3-8: PSO Output Interface Connector Pin Assignment (TB302)
Pin # Description
1 Opto-Isolator Power
2 PSO Output
3 Opto-Isolator Common
Table 3-9: PSO Output Mating Connector
Type
3-Pin Terminal Block
N O T E : If your Ensemble HPe 150/200 was purchased after July 2013, refer to
N O T E : If your Ensemble HPe 150/200 was purchased before July 2013, refer to
www.aerotech.com
3-8). Multiple opto-coupler options are available, depending on output speed,
Aerotech P/N Phoenix P/N
ECK01449
Chapter 3
Ensemble HPe 150/200
Tightening
Torque (Nm)
1881338 N/A
In/Out/Bi
Input
Output
Input
2
Wire Size: mm [AWG]
0.5 - 0.080 [20-28]
Section 3.2.1.
Section 3.2.3.
71