Power Connection - Christie Mirage S+14K User Manual

INSTALLATION & SETUP
Communicating to
2.7 Power
Connection
2-26
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
'
To relay all messages to all ports—RS232, RS422, and Ethernet—set the "Network
All Ports
Routing" option in the Communications menu for each projector to "All Joined".
This configuration is useful if you are using a non-RS232 controller with the RS232
linking available between these projectors. For example, you may want to use both an
RS422-compatible controller and an Ethernet-connected PC for working with a
network of projectors linked via their RS232 in/out ports (Figure 2.37).
To isolate just RS422 communications, select "RS232 and Ethernet Joined". In
Figure 2.37, only projector #3 will respond to the RS422 controller. To isolate just
Ethernet communications, select "RS232 and RS422 Joined"—only projector #1 will
respond via Ethernet.
Plug the projector's high-current line cord into the line input socket located in the
lower right corner of the rear panel of the projector, then plug the 3-pronged end of
the line cord into a grounded AC outlet. Input voltage to all Roadster S+ and Mirage
S+ models must be capable of 200 –240 VAC. Use the proper power source and the
high-current rated line cord provided. See Section 6, Specifications for all power
requirements.
Caution for Shutdowns: Once the projector is turned off (
cooling fans will continue to run for approximately five minutes to ensure that the
projector and lamp have sufficiently cooled, at which point the fans will
Figure 2.36. Keeping Communications Separate (default)
Figure 2.37. Joining All Networks
WARNING
Do not attempt operation if the AC supply and cord are
not within the specified voltage and power range.
), the lamp