Christie Mirage S+14K User Manual page 72

OPERATION
3-38
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
network of projectors, if you discover that a projector has a different baud rate, make
sure to use the pull-down list and select the correct baud rate using the
not just scroll this control with
data bits, no parity.
Projector
Enter a three-digit number (such as "001") to assign or change a number to the
projector currently in use. If the current projector already has a number assigned, that
number will appear here (for example, "004" in Figure 3.17, above). Numerical
identity for projectors enables you to communicate with a single projector within a
multiple-projector application (see also
make a mistake in assigning or changing the projector number, press
Network Routing
NOTE: Not applicable for stand-alone projectors or simple serial networks with only
one type of controller and linking.
Select "Separate" (factory default) to keep RS232, RS422 and Ethernet
SEPARATE:
messages on their respective paths instead of being broadcast to the other types of
ports. In Figure 3.18A, RS422 controls only the projector to which it is connected. In
Figure 3.18B, either RS232 or RS422 will control the network.
Figure 3.18. Using the "Network Routing" Option
RS232 AND RS422 JOINED:
will be relayed to all RS232or RS422 ports. Any Ethernet communication, however,
will not.
RS232 AND ETHERNET JOINED:
relayed to the Ethernet port, and vice versa. Any RS422 communications will be
isolated.
All messages reach all ports, regardless of type.
ALL JOINED:
or keys. Serial communication is always 8
key in 3.3 Using the Keypads). If you
Proj
Messages originating from an RS232 or RS422 controller
Messages to and from the RS232 ports will also be
key—do
to cancel.
Exit