Christie Mirage S+14K User Manual page 15

Alignment Procedure
Downloaded From projector-manual.com Christie Manuals
Figure 2.14. Align Holes in Mounts and Legs, and LOCK with Pin
'
STEP 8
Insert (3) safety pins and LOCK all
At each of the (3) stacking points, insert the safety pin fully through the holes in the
stacking mounts and stacking legs (Figure 2.14). Ensure that each pin is fully inserted to
engage the safety lock and secure the projectors together. Failure to engage the safety
lock could cause the projectors to separate and result in injury or death.
'
STEP 9
Leg Nuts
Before hoisting, firmly tighten the nuts on the (2) rear stacking legs (Figure 2.14). Or,
if you are ready to align the projectors to one another, leave these nuts slightly loose
until after the alignment.
STEP 10 '
Repeat STEPS 1–9 for a third projector.
'
Stacked projectors must be correctly aligned to one another so that the resulting
display is optimized and as sharp as possible. If you are also hoisting the stack, hoist
the stack into place first, then align. Lock all stacking hardware into place to maintain
your alignment.
WARNING
Critical Safety Procedure.
WARNING
Failure to engage the safety lock could cause the
projectors to separate and result in injury or death.
WARNING
Never stack more than 3 projectors.
IMPORTANT
Make sure the stacking legs have been extended
by at least 1 inch, and are slightly loosened.
Refer back to
INSTALLATION & SETUP
Figure 2.11
.
Roadster / Mirage S+ User's Manual
2-9