Christie Mirage S+14K User Manual page 13

Downloaded From projector-manual.com Christie Manuals
STEP 1 '
Position the projectors
Place the projectors to be
stacked on a secure table or
cart.
• Place one projector on its
side to access its
adjustable feet and
stacking legs (Figure
2.10).
• Orient the other projector
in either upright or
inverted position as
required (remember,
each projector in a stack
must be in the same
orientation).
'
STEP 2 Fully retract the (4) adjustable feet
Retract each foot as far as possible by turning it clockwise.
•
If upright – retract the feet on top projector.
•
If inverted – retract the feet on bottom projector.
STEP 3 '
Extend the (3) stacking legs
Extend the stacking legs by turning
them so that at least 1 inch of thread is
visible on each. This clearance
accommodates the up-or-down
movement for aligning the images from
stacked projectors. Extend all 3 legs
equally (Figure 2.11).
• If upright – extend legs on top
projector (shown).
• If inverted – extend legs on bottom
projector.
Extend the stacking legs
equally by at least 1 inch.
STEP 4 '
Loosen the rear stacking leg nuts
On the rear stacking legs, loosen the nuts so the legs have some lateral movement for
easier alignment with the stacking mounts on the other projector.
IMPORTANT
INSTALLATION & SETUP
Figure 2.10.
Figure 2.11. Extend 3 Stacking Legs
(UPRIGHT STACK SHOWN)
Roadster / Mirage S+ User's Manual
2-7