Christie Mirage S+14K User Manual page 50

OPERATION
Creating a New
– AUTOMATIC –
3-16
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
Shown at right is a sample channel list as
would be available from
called the channel list.
NOTE: The
or not, depending on what you have defined for
"Display Channel List" (see Menu
Preferences later in this section).
In order to access channels by using
the keypad, you must first create the channels.
See below.
'
To use a new source with the projector, a new channel must be added to projector
Channel
memory so that the projector will respond properly to an input signal from that
source in the future. A new channel can be created automatically, as described here,
or it can be copied from an existing channel and then edited as necessary (see
Copying or Deleting Channels later in this section).
When you select a direct input (
existing channels are searched for matching input and signal parameters. If no match
to the incoming input signal is found, a new channel is temporarily created based on
factory-defined defaults for this type of signal. The channel number assigned is the
lowest available number from 1-50.
NOTES: 1) An automatic channel will be discarded unless one or more of its
parameters are changed, and will not appear in the channel list (see below). 2) If two
channels have the same distinguishing source characteristics except for the reversal
of sync connectors (i.e., H-sync and V-sync, are switched), they are still defined as
distinct channels. 3) You cannot define a new channel without an incoming signal.
If the incoming signal does match an existing channel, the image will be set up and
displayed as usual according to the parameters currently defined for that channel.
USING A CHANNEL:
can normally select a
channel at any time by
pressing Chan
you want to prevent a
channel from appearing in
this list, you must edit the
channel as described in
Channel Edit later in this
section. Such a channel can still be selected by entering its number as shown at right.
NOTES: 1) The current channel is highlighted upon entering the channel list, or, if
this channel is not displayed here, the first channel in the list is highlighted. 2)
Channels created automatically do not appear in the channel list unless a parameter
for the channel has been changed.
Chan . This is typically
Chan key may display a channel list
Chan
,
Input 1 Input 2
You
(see right). If
on
Channel List
, Input 3 , Input 4 , Input 5 or Input 6 ), the projector's