Power connection
The projector uses an innovative dual AC inlet power system that offers two power modes.
To operate at full brightness (six lamps), power the projector using AC Input 1 if the appropriate high
power source is available. To operate in limited power mode (single lamp), power the projector using
standard lower power sources using AC Input 2. A different power cord is provided for each power
source. A 30A rated wall breaker is required at the installation when using Input 1. A 15A rated wall
breaker is required at the installation when using Input 2.
Projector components
Identify the main components of the projector.
A
B
L
M
N
O
K
ID
Component
A
Communication and input
panel
B
Mounting and rigging holes
C
User interface air filter door
D
Display panel
E
Keypad interface
Boxer 4K User Guide–Boxer 4K20 (Bb.4) and Boxer 4K30 (Bb.1)
020-101777-16 Rev. 1 (05-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
C
D
E
F
G
Q
P
Description
Connects media sources to either the ports on the option cards or the
IMXB.
M12 x 1.75 holes for projector feet installation and offer mounting and
rigging points.
Provides to the user interface air filter.
Displays the projector menus and status.
Controls the projector.
J
H
I
R
S
T
U
V
Introduction
15