Christie Mirage S+14K User Manual page 73

OPERATION
(SUBMENU)
Ethernet Settings
NOTES: 1) Recommended for network administrators only.
Enable this checkbox if you want a DHCP server to automatically change the
DHCP:
projector's default IP address (0.0.0.0) to one that is valid and unique for use on the
current Ethernet network. On networks without a DHCP server, or to simply override
the automatic DHCP server function, delete the checkmark and enter the new "IP
Address" settings desired. Remember that only a 0.0.0.0 address will trigger the
DHCP addressing service, and only when the DHCP checkbox is enabled.
Enter a valid and unique IP address for use on the network to which the
IP ADDRESS:
projector is currently connected. This address will overwrite any previous IP address
such as the projector's factory-defined default (0.0.0.0), or one that has been assigned
by a DHCP server or other user. It takes approximately 10 seconds for the projector
to respond at its new address.
On some Ethernet networks, firewall restrictions may require that the port
PORT:
number of the projector be changed from its default of 3002. If so, enter a new valid
port number here.
Broadcast Key
Enter a checkmark if you want keypad commands sent to one projector to be relayed
to all projectors in a serial network. Note that the key will temporarily
Proj
"override" the effect of a broadcast setting and allow you to control a specific
projector when necessary. Disable the setting for all but one (any) projector in a
network.
Backlight
Toggle to turn the built-in keypad backlighting on and off.
Front IR / Back IR
As needed for your application, set to "on" so that the front and/or rear IR sensor
locations on the projector respond to the IR keypad. Set to "off" to disable.
To disable both IR sensors, you cannot use the IR remote keypad to select the second
setting. This safeguard prevents accidentally disabling an IR keypad while you
OFF
are using it. Instead, use either the built-in keypad or a wired remote (optional) to set
the remaining active sensor to . The projector will no longer respond to an IR
OFF
remote keypad.
Wired Keypad
The wired keypad is ON by default to when connected to the rear of the projector.
The projector will then respond to incoming commands from this port. To disable the
wired keypad, you must use a different keypad—the built-in or an IR remote
keypad—to select "off". This safeguard prevents you from accidentally disabling the
wired keypad during use.
3-39
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals