Christie Mirage S+14K User Manual page 89

Downloaded From projector-manual.com Christie Manuals
Figure 3.28. Copy X/Y Values into All Projectors
6. In each projector, judge by eye and adjust x/y coordinates slightly in the following
manner:
To match reds, decrease
"Red X" until full field red
screens match.
To match greens, decrease
"Green Y" until full field
green screens match.
To match blues, increase
both "Blue X" and "Blue Y"
until full field blue screens
match.
NOTE: For speed, enable the
"Auto Color Enable" checkbox. Each color coordinate you select will then
automatically trigger a full field display of the corresponding color.
Alternatively, use the Color Saturation menu for these adjustments or to fine tune.
These coordinate adjustments move the three color points closer together (refer back
to the chromaticity chart shown in Figure 3.22) to establish a "shared" gamut
attainable by all projectors in your group. Adjust only as necessary to ensure that the
resulting color palette is as large as possible. When done, you may need to adjust
lamp power slightly.
7. All screens should now be color-matched and the will remain matched upon exit
from the menus. Apply this new "User" gamut to a source at any time by selecting
it in the "Select Color Adjustment" list accessed in the Advanced Image Settings
menu.
Roadster / Mirage S+ User's Manual
OPERATION
3-55