Christie Mirage S+14K User Manual page 68

OPERATION
3-34
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
more time for shutters in 3D glasses to open/close, ensuring that each eye sees the
full display intended for it. Symptoms of cross-talk and/or color artifacts can indicate
need for adjustment. The Dark Interval range of adjustment depends on the vertical
frequency of your source—the higher the frequency, the smaller the range.
NOTE: See separate Using 3D in Mirage manual provided for more information.
3D STEREO SYNC LOCKING —
stereographic 3D signal locks to the vertical sync output so that signals are
synchronized, and 2) whether or not the 3D frames must be inverted, i.e. swapped
left-with-right. The correct setting ensures that the projector's 3D display of left/right
frames is synchronized with the rest of the 3D system components so that left/right
image data is seen by the intended eye. Select the option corresponding to your 3D
source connections and timing, and use only if the Mirage 3D Stereo Sync Cable is
connected between the projector's GPIO port and a server. Keep this adjustment OFF
(default) when you are not using the Mirage 3D Stereo Sync Cable.
With your sync cable, Z-screen and, if desired, emitter connected as described in the
Using 3D in Mirage manual, select the option suited to your 3D configuration (see
above). If Frame Delay is 2 (or 0), do not invert; if frame delay is 1 or 3, invert.
Generally, an "Unlocked" setting is synchronized with the incoming L/R signal
rather than the vertical sync output, and may be needed only with multi-projector
installations in which the vertical sync outputs vary.
NOTE: See separate Using 3D in Mirage manual provided for more information.
3D STEREO SYNC
Define which
SELECT —
of the Mirage 3D Stereo
Sync Cable's input
connecters is routed from
your server. Use only if
the cable is present.
— Set when the L/R frames begin, defining the best
3D STEREO SYNC DELAY
reference point for synchronizing the display with your glasses. Proper adjustment of
this delay should eliminate cross-talk and odd colors caused by timing differences
between the glasses and the projected display. Use this slidebar only if the Mirage 3D
Stereo Sync Cable is connected between the projector's GPIO port and a server.
Slidebar values indicate the number of lines that are delayed.
— When checked, the output image frame rate is locked to the
FRAME LOCK ENABLE
input signal frame rate when possible. When the images are not locked, the input and
the output will run as close to the same rate as possible, but frames may occasionally
be duplicated or dropped.
This option defines 1) whether or not the incoming