Christie Mirage S+14K User Manual page 30

INSTALLATION & SETUP
Ethernet Networks
2-24
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
NOTE: You must enable this combination of RS422 and RS232 in the
Communications menu. Set the "Network Routing" option to "RS232 and RS422
Joined". See Section 3 for details.
Then chain the projectors together by connecting an
(already connected to the computer/controller through the
port on the next projector in the chain. Continue connecting projectors in this manner
until you've reached the last projector in the chain, so that only the last projector has
RS232
one unused port. See Figure 2.33.
Note that communication parameters such as baud rate must be set to match the
particular controlling device before connecting as a network—refer to the
documentation that came with your controlling device in order to determine the
proper baud rate. See 3.7, Adjusting System Parameters and Advanced Controls if you
need help changing the projector baud rate. In addition, set the Network Routing to
"RS232 and RS422 Joined" if you want to reach all projectors.
NOTES: 1) To avoid damage, connect only properly wired serial communication
cables. See Appendix C for details. 2) It is recommended that each RS232
communication cable be no more than 25 feet in length. Use high quality cables.
'
ETHERNET NETWORK SETUP
use standard CAT5 cable to connect each projector's Ethernet port to a hub on to the
network. A controller or PC must also be connected to the hub. See Figure 2. 34.
Figure 2.33. Mixed Serial Network
: To add one or more projectors to an Ethernet network,
Figure 2. 34. Typical Ethernet Network
RS232
port of the first projector
RS422 RS232
port) to an