Christie Mirage S+14K User Manual page 14

INSTALLATION & SETUP
2-8
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
• If upright – release on top projector.
• If inverted – release on bottom projector.
STEP 5 '
Release and remove (3) safety pins
The safety pins must be removed from the
stacking mounts so that the stacking legs can fit
into the mounts (Figure 2.13).
• If upright – remove the pins from the mounts
on the bottom projector.
• If inverted – remove the pins from the
mounts on the top projector.
STEP 6 '
Place top projector on bottom projector
With one person on each side, lift the top projector on to bottom projector, aligning
all three stacking points between projectors. Legs should fit inside stacking mounts.
STEP 7 '
Align holes in (3) stacking mounts and (3) stacking legs.
On each stacking mount, turn the adjusting wheel slightly until the hole in the top
portion of the mount lines up with the hole in the stacking leg (Figure 2.14).
NOTE: You can increase leverage by using a screwdriver in the holes.
Figure 2.12. Loosen 2 Nuts
Figure 2.13. Remove Safety Pins
WARNING
Minimum of 2 people required.