Christie Mirage S+14K User Manual page 112

MAINTENANCE
4-10
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
'
STEP 5
Insert new lens.
Note: Remove small rear cap! Keep front cap on.
•
Electrical connector: Line up male connector on the lens with the female
connector on the connector slide assembly.
•
Insert lens: Align the tabs on the lens plate lock with the slots in the lens
retainer ring. Push the lens in approximately ½ inch.
•
Rotate the lens: Rotate the lens clockwise until the tabs are tightly secured
and the lens release button CLICKS.
'
STEP 5
Power Up
Remove the lens cap and power up the projector.
'
STEP 6 Reposition the Projector for New Lens
Reposition the projector closer or further from the screen as necessary for the screen
and the new lens type – refer to lens descriptions in Section 2 and Section 6 and
Appendix D, Throw Distance. In a permanent installation, always use the appropriate
throw distance formula to calculate the best position for the projector.