Christie Mirage S+14K User Manual page 49

Downloaded From projector-manual.com Christie Manuals
SWITCH TO AN INPUT IN EITHER ONE OF TWO WAYS –
key — , , Input 3 , Input 4
Input 1 Input 2
from one of the six inputs connected to the projector. Or, if the "Numbers Select
Main Image" option, found in the PIP menu, is to enable, press numbers 1-6 on the
number keypad . With either method, the image will be displayed according to the
following:
If it is the first time you have used the source/input (or if you used the input but
did not define a channel by adjusting anything), the projector will recognize the
new input signal based on its frequencies and polarities, and will automatically
display an image according to default settings for such a signal. In general, the
default fills the screen as fully as possible. This and other default image settings
depend on the incoming source.
If you used the source once before and changed a display parameter such as
contrast, V-Position, etc., then a channel was automatically created and still exists
in projector memory (see below).
If more than one channel exists for the input, the image will be displayed
according to the setup parameters for the first channel with matching
characteristics.
If PIP is enabled, an input key changes the PIP (secondary) image only. To switch
the main input, use the keypad number keys with "Numbers Select Main Image"
activated.
NOTES: 1) Inputs 7 and 8 require the Dual SD/HD-SDI module in either of the
projector's option slots. For their selection, see also 3.3, Using the Keypads. 2)For
more information on Numbers to Select Main Image, see 3.8, Working with PIP or
Seamless Switching.
A channel is a collection of measurements, locations and settings that
CHANNEL -
tailor the display of a signal to your specific needs. Since source types and
applications can vary greatly, you will likely want to adjust and define a wide variety
of parameters, such as brightness, contrast, size, etc., in order to customize and
optimize the display from or for a particular source. For example, the display settings
you choose for a VCR source may be very different from those you choose for a high
resolution computer source, or one signal may simply vary from another signal used
previously through the same input location. Once you have adjusted a display
parameter, such as pixel tracking or contrast, all current settings are collectively
stored in the projector's memory as a unique 2-digit channel, such as
have numerous distinct channels available for the same input, any of which can be
selected by using the Chan
, Input 5 or Input 6 — is a quick and seamless way to display
key on the keypad followed by the 2-digit channel number.
Roadster / Mirage S+ User's Manual
OPERATION
Pressing the appropriate direct
. You can
3-15