Christie Mirage S+14K User Manual page 40

OPERATION
Wired Remote
Guide to Keypads '
Keypad Commands
3-6
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
'
With the addition of a cable (supplied), the IR remote converts into a wired remote
keypad. Simply connect to the
remote is recommended when the rear built-in keypad is inaccessible or if lighting
conditions are interfering with IR transmission.
NOTE: Batteries must remain in the remote to use the laser feature.
Press keys one-at-a-time; there are no simultaneous key combinations required.
1)
Note that three keys—Power, Shutter and OSD—are "press-and-hold" keys that
2)
do not function with a typical quick press-and-release keypress (see Figure 3.3).
Hold arrow keys down for continuous adjustment/movement in one direction. In
3)
serial networks, pause briefly between adjustments to ensure that more distant
projectors can "keep up" with the commands.
If you press a key while the projector is still responding to the previous action,
4)
such as during power-up, the second key press may not take effect.
'
Specific keypad commands are explained below:
Power ON/OFF
Press and hold
Or press and release
guarantee the correct toggle (useful if you are unsure of the present state).
NOTES: 1) After powering down, the lamp cooling fan remains on for approximately
5 minutes to cool the lamp. 2) It is a good idea to avoid turning a projector back on
until it has been off for several minutes. Hot re-strikes of the lamp may reduce lamp
life.
Test Test
Press to scroll through the projector's internal test patterns. When a test pattern
Test
is up, use
Auto
Auto
Setup
Auto
Press to initiate an automated process in which the projector optimizes critical
Setup
display parameters such as size, position, pixel tracking, etc., for the current unlocked
channel. These parameters are listed in Table 3.1. An Auto Setup can save time in
perfecting a display, and you can further modify the settings as desired.
OPTIMIZES:
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
Channel
Channel
Press to select a specific source setup (channel) defined and stored in projector
Channel
memory. Once you enter a 2-digit channel number (or, if there is a list displayed,
REMOTE
input at the rear of the projector. The wired
briefly to toggle the projector on or off with a single keystroke.
followed immediately by
to scroll through the patterns without going back to the input.
Table 3.1. Auto Setup
What an "Auto Setup" Does
SETS TO DEFAULT:
Contrast
Brightness
Auto Input Level (off)
Detail
Filter
Luma Delay
(on) or (off) to
(if video source)