Christie Mirage S+14K User Manual page 41

Downloaded From projector-manual.com Christie Manuals
highlight it and press
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust an image from a new source.
NOTE: Channel (
Channel
not the Display Channel List option is enabled in the Menu Preferences menu. You
can choose to use a scrollable list of channels when you press
to enter the desired channel number "blind", i.e., without on-screen feedback. See
Menu Preferences later in this section.
Input 1
Input 1
Press to display from the data input source connected to BNCs labeled
Input 1
If PIP is enabled, pressing this key will change the PIP source.
Input 2
Input 2
Press to display from the DVI source connected to
Input 2
pressing this key will change the PIP source.
Input 3
Input 3
Press to display from the composite video source connected to
Input 3
enabled, pressing this key will change the PIP source.
Input 4
Input 4
Press to display from the S-video source connected to
Input 4
enabled, pressing this key will change the PIP source.
Input 5
Input 5
Press to display from the
Input 5
PIP is enabled, pressing this key changes the PIP source. If there are two inputs
connected here, such as if the Dual SD/HD-SDI is installed, the second input (B) is
INPUT 7.
considered
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module,
press . This switches to either
Input 5
the Dual SD/HD-SDI Module inputs (A or B) was last used. Press
to display from the other Dual SD/HD-SDI Module input.
Input 6
Input 6
Press to display from the
Input 6
PIP is enabled, pressing this key changes the PIP source. If there are two inputs
connected here, such as if the Dual SD/HD-SDI is installed, the second input (B) is
INPUT 8
considered . If you are using the built-in keypad or the remote keypad, press
INPUT 6 INPUT 8
to access
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module,
press . This switches to either
Input 6
), the display will automatically change and update
) key behavior during a presentation depends on whether or
INPUT 5
interface module installed in the Option 1. If
INPUT 5 INPUT 7
Press to access
INPUT 5
, press
Input 5
INPUT 5
INPUT 6
interface module installed in the Option 2. If
as follows:
INPUT 6
, press
Input 6
INPUT 6
Roadster / Mirage S+ User's Manual
OPERATION
, or you may prefer
Channel
INPUT 2
. If PIP is enabled,
INPUT 3
INPUT 4
. If PIP is
as follows:
INPUT 7
again. This switches to
INPUT 7
or , depending on which of
Input 5
INPUT 8
again. This switches to
INPUT 8
or , depending on which of
INPUT 1.
. If PIP is
.
again
.
3-7