Christie Mirage S+14K User Manual page 28

INSTALLATION & SETUP
2-22
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
Figure 2.30. Connecting Ethernet
Upon connection to an Ethernet network, the projector's factory default IP address of
0.0.0.0 will automatically enable the DHCP function (if available on the network) to
assign a new IP address that is valid and unique for that network. Or, if there is no
DHCP function available on the network (or if a specific static IP address for the
projector is preferred or required), you can set the address in the Ethernet Settings
submenu or via an ASCII serial command.
NOTE: Make sure the projector is connected to the network before attempting to
change its IP address.
Regardless of how it is assigned, once a projector has a valid and unique address it
will respond to commands sent to this address. To determine the projector's current
IP address, consult the Status or Communications menus.
Refer to 3.7, Adjusting System Parameters and Advanced Controls for further
information about setting up and using a projector connected via Ethernet.
The GPIO Port
The General Purpose In-Out (GPIO) port enables integration of the projector within
an established control system (Figure 2.31). ASCII commands sent via the GPIO link
are stored in projector memory, where they can be triggered as a sequence of events
in the future. See Appendix E.