Christie Mirage S+14K User Manual page 109

Downloaded From projector-manual.com Christie Manuals
'
STEP 7
Re-install retaining bar
Note: Correct positioning of the lamp module is essential. Ensure that the retainer
bar is in place and secure screws in the order described below.
See Figure 4.5. Position the retaining bar along the bottom edge of the lamp module,
with ends under alignment guides. If the bar does not fit, push the lamp module
further in.
Secure screw
Secure screw
Finish securing screw
'
STEP 8 Close lamp door
Close the door and lock its 2 screws.
'
STEP 9
Record the serial number of the new lamp
1. Power up the projector.
2. In the Lamp menu, select "Change Lamp".
3. In the Lamp S/N text box, enter the serial number.
4. Press
begin to log time for the new lamp.
NOTES: 1) Once entered, the new lamp serial number is also automatically added to
the Status menu. 2) Lamp life data is required for warranty claims.
IMPORTANT
The tightening order of the screws is
critical for proper lamp contact and alignment.
until just engaged.
B
fully.
A
.
B
Figure 4.5. Install Retaining Bar
Important
The lamp module is calibrated for maximum
performance and brightness in this projector. Do not
attempt to re-align or adjust lamp module.
to record the number and to reset the lamp timer. The timer will now
IMPORTANT
If you neglect to enter a serial number, the lamp timer
will not reset to "0" and will therefore be inaccurate. The
lamp life limit may then expire prematurely.
MAINTENANCE
Roadster / Mirage S+ User's Manual
4-7