Christie Mirage S+14K User Manual page 110

MAINTENANCE
Filter Replacement
4.5 Replacing the
Lens
4-8
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
'
Replace the air filter when the lamp module is replaced, or more frequently if
operating the projector in a dusty environment. The filter is located adjacent to the
lens.
'
STEP 1
Turn off the projector, cool, and unplug
Before removing or installing a filter, turn off the projector and allow it to cool for
five minutes before unplugging. Make sure the lens cap is on.
'
STEP 2
Remove filter door
See Figure 4.6. Loosen the screw at
the top of the filter grille/door. Lift
the door away from projector.
'
STEP 3 Replace the filter
Remove the old filter and insert the new one. Follow the
airflow arrows on the filter for correct orientation (see
right).
Use Christie filters only. Never operate
the projector without the filter installed.
'
STEP 4 Re-install the filter grille/door
Secure with the single top screw.
A variety of lenses can accommodate different throw distances and specific types of
installations. See page 6-1 for details. To change a lens, follow the steps below. No
tools are required for "compact" lenses shown.
'
STEP 1 Turn off the projector, cool and unplug
NOTE: If necessary, a lens can be swapped out while the projector is running, but
this can result in dust being drawn into the projector. Avoid if possible.
Before removing or installing any lens, turn off the projector and allow the fans to
cool the lamp before unplugging the projector. Ensure that the lens cap is on.
WARNING
Unplug the projector
Figure 4.6. Remove Air Filter Door
WARNING
Figure 4.7