Source Connections - Christie Mirage S+14K User Manual

2.4 Source
Connections
RGB Signals
Downloaded From projector-manual.com Christie Manuals
Sources connect to the Input Panel located on the rear of the projector. As shown in
Figure 2.24, the upper right corner (
an external analog RGB source, or it can also be used for YPbPr signals or additional
video sources. Just to the left of the BNCs, the DVI-I connector (
digital or analog display signals from a computer. Connect analog composite video at
INPUT 3
, or S-video at
INPUT 5
DVD players. At
compatible SMPTE signals (note this module can be moved to
There are also several optional interfaces available for connecting other sources—
these interfaces slide into the remaining unused option slot, and can be done while
the projector is running.
NOTES: 1) See Section 6, Specifications for details regarding compatible inputs. 2)
Use high quality shielded cables only for all connections. 3) The Dual SD/HD-SDI
module shown is standard on the Roadster S+, optional for the Mirage S+ series.
Figure 2.24. Input Panel
'
INPUT 1
consists of 5 BNCs (connectors) for linking to a variety of RGB sources such
as a PC, Mac, DEC, Sun, SGI, and others. This projector supports multiple sync
types with RGB signals: sync-on-green, composite sync, and separate H & V syncs.
NOTE: Depending on your source, you may need a custom adapter cable with BNC
connectors at the projector end and a different type of connector at the other (such as
a 15-pin "D" connector for some computer sources). Contact your dealer for details.
SYNC
Connect the BNC input(s) first. Then connect the red, green, and blue source
RED GREEN
outputs to the ,
sync-on-green, only the red, green, and blue connections are required. If the source
provides a composite sync output, connect it to the
the source provides separate horizontal and vertical sync outputs, connect horizontal
SYNC
sync to the input labeled
VERT.
labeled See Figure 2.25, below.
INPUT 1
) typically accepts an RGB signal from
INPUT 4
from devices such as VCRs, laser disk players, or
INPUT 1),
(below connect serial digital YCbCr (4:2:2) or
BLUE
, and BNCs on the
HOR/COMP,
and connect vertical sync to
Roadster / Mirage S+ User's Manual
INSTALLATION & SETUP
INPUT 2
) accepts
INPUT 6
if desired)..
INPUT 1
panel. If the source uses
SYNC HOR/COMP
input labeled
SYNC
. If
input
2-17