Christie Mirage S+14K User Manual page 104

MAINTENANCE
Lamp and Filter
Replacement
Power Cord
and Attachments
Ventilation
4-2
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
'
LAMP:
Do not operate the Bubble lamp for more than the lamp's warranty limit; risk
of the lamp shattering increases as a result of changes in the quartz glass that occur
with use. Operation beyond the lamp's warranty limit also significantly reduces
brightness output.
Never attempt to remove the lamp housing directly after use.
The lamp is under great pressure when hot and may explode,
causing personal injury and/or property damage. Allow to cool
The Bubble lamp operates at a very high temperature and pressure.
Failure to allow the lamp to sufficiently cool prior to handling could
result in an explosion causing personal injury and/or property
damage. After turning the projector off it is important that you wait
at least five minutes before unplugging it. This provides enough time
for the internal lamp cooling fans to cool the lamp and to automatically shut off. Cool
completely before handling.
FILTER:
Replace the front filter when you replace the lamp or sooner. If this filter is
not replaced, air flow may become restricted and cause the projector to overheat.
See 4.4, Replacing the Lamp and Filter for the complete replacement procedure.
'
Only use attachments or accessories recommended by Christie, such as the specific
power cord supplied. Use of other attachments or accessories with this projector may
result in the risk of fire, shock or personal injury.
Use only the AC power cord supplied. Do not attempt operation
if the AC supply and cord are not within the specified voltage
Do not allow anything to rest on the power cord. Locate the projector where the cord
cannot be abused by persons walking on it or objects rolling over it.
Operate the projector at the specified voltage only. Do not overload power outlets
and extension cords as this can result in fire or shock hazards.
The projector is equipped with a three wire plug having a third (grounding) pin. This
is a safety feature. If you are unable to insert the plug into the outlet, contact an
electrician to have the outlet replaced. Do not defeat the safety purpose of the
grounding-type plug.
Before unplugging the power cord, make sure the internal lamp cooling fans have
shut off. The fans automatically shut off when the projector has adequately cooled
down.
WARNING
completely.
WARNING
Use only lamps supplied by Christie.
WARNING
Use only filters supplied by Christie.
WARNING
and power range. See Section 6.