Replacing The Operator Information Panel Assembly - IBM System x3750 M4 Type 8722 Installation And Service Manual
Hide thumbs
Also See for System x3750 M4 Type 8722:
- Product manual (45 pages) ,
- Installation and service manual (882 pages)
Table of Contents
Advertisement
Replacing the operator information panel assembly
To install the operator information panel, complete the following steps.
1. Read the safety information that begins on page "Safety" on page vii and
"Installation guidelines" on page 33.
2. From the front of the server, align the panel with the slot and slide the operator
information panel into the server until it clicks into place.
Operator information
panel
3. Reconnect the cable to the rear of the operator information panel assembly.
Note: Make sure that cable is installed correctly by using the keys on the
connector and the keys on the cable. Incorrect installation of the cable can
damage the operator information panel.
4. Install the cover (see "Replacing the server top cover" on page 207).
5. Slide the server into the rack.
6. Reconnect the power cords and any cables that you removed.
7. Turn on the peripheral devices and the server.
Chapter 6. Removing and replacing components
261
Advertisement
Table of Contents
Troubleshooting
