Replacing The Operator Information Panel Assembly - IBM System x3650 M5 Installation And Service Manual

Operator information
panel assembly
Figure 210. Operator information panel removal
6. If you are instructed to return the operator information panel assembly, follow
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.

Replacing the operator information panel assembly

Use this information to replace the operator information panel assembly.
About this task
To install the operator information panel, complete the following steps.
Procedure
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 283.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables, if necessary.
3. Remove the top cover (see "Removing the top cover" on page 146).
4. Slide the operator information panel into the server until it clicks into place.
Release latch
Chapter 5. Removing and replacing components
255