Motorola WiNG 5.7.1 System Reference Manual page 602

7 - 24 WiNG 5.7.1 Access Point System Reference Guide
Attributes
Server Pooling Mode
Client Attempts
Request Timeout
ID Request Timeout
Retransmission Scale
Factor
Cisco VSA Audit Session
Id
Accounting Delay Time
Accounting Multi
Session ID
Chargeable User ID
Add Framed IP Address
Framed MTU
RFC5580 Location
Information
RFC5580 Operator Name
Service-Type
NAS IPv6 Address
Proxy NAS Identifier
Lists whether the format specified applies only to the user name/password in mac-auth
or for all attributes that include a MAC address, such as calling-station-id or called-
station-id.
Controls how requests are transmitted across RADIUS servers. Failover implies traversing
the list of servers if any server is unresponsive. Load Balanced uses all servers in a round-
robin fashion. The default setting is Failover.
Defines the number of times (1 - 10) an EAP request is transmitted to a wireless client
before giving up. The default setting is 3.
Defines the time after which an EAP Request to a wireless client is retried.
Defines the time (1 - 60 seconds) after which an EAP ID Request to a wireless client is
retried. The default setting is 30 seconds.
Configures the scaling of the retransmission attempts. Timeout at each attempt is a
function of the request timeout factor and client attempts number. 100 (default setting)
implies a constant timeout at each retry; smaller values indicate more aggressive (shorter)
timeouts, larger numbers indicate more conservative (longer) timeouts on each successive
attempt.
Configures a vendor specific attribute (VSA) for CISCO to allow CISCO's Identity Services
Engine (ISE) to validate the compliance of a client to the network's policies such as the
validity of the virus definition files for the antivirus software or the definition files for a
anti-spy ware software.
Select this option to enable the support of an accounting delay time attribute within
accounting requests. This setting is disabled by default.
Select this option to enable the support of an accounting multi session ID attribute. This
setting is disabled by default.
Select this option to enable the support of chargeable user identity. This setting is
disabled by default.
Select this option to add an IP address attribute to access requests. This setting is
disabled by default.
Set the framed MTU attribute (from 100 - 1500) used in access requests. The default
setting is 1400.
Select a support option for the RFC5580 location attribute. Options include None, include-
always and server-requested. The default setting is None.
Provide a 63 character maximum RFC5580 operator name.
Set the service type attribute value. Options include framed (default setting) and login.
Select this option to provide support for NAS IPv6 formatted addresses when not proxying.
This setting is disabled by default.
Select a RADIUS attribute NAS identifier when proxying through the controller or RF
Domain manager. Options include originator (default setting) or proxier.