L2Tpv3 Tunnels - Motorola WiNG 5.7.1 System Reference Manual

13.3.16 L2TPv3 Tunnels

Access Point Statistics
Access points use L2TP V3 to create tunnels for transporting layer 2 frames. L2TP V3 enables an access point to create tunnels
for transporting Ethernet frames to and from bridge VLANs and physical ports. L2TP V3 tunnels can be defined between WING
devices and other devices supporting the L2TP V3 protocol.
To review a selected access point's L2TPv3 statistics:
1. Select the Statistics
2. Select System
connected access points.
3. Select L2TPv3.
The access point
Tunnel Name
Local Address
Peer Address
Tunnel State
menu from the Web UI.
from the navigation pane (on the left-hand side of the screen). Expand a RF Domain and select one of its
Figure 13-64 Access Point - L2TPv3 screen
L2TPv3 Tunnels screen displays the following:
Displays the name of each listed L2TPv3 tunnel assigned upon creation. Each listed tunnel
name can be selected as a link to display session data specific to that tunnel. The Sessions
screen displays cookie size information as well as psuedowire information specific to the
selected tunnel. Data is also available to define whether the tunnel is a trunk session and
whether tagged VLANs are used. The number of transmitted, received and dropped packets
also display to provide a throughput assessment of the tunnel connection. Each listed session
name can also be selected as a link to display VLAN information specific to that session. The
VLAN Details screen lists those VLANs used an access point interface in L2TP tunnel
establishment.
Lists the IP address assigned as the local tunnel end point address, not the tunnel interface's
IP address. This IP is used as the tunnel source IP address. If a local address is not specified,
the source IP address is chosen automatically based on the tunnel peer IP address.
Lists the IP address of the L2TP tunnel peer establishing the tunnel connection.
States whether the tunnel is idle (not utilized by peers) or is currently active.
13 - 109