Radio Power Overrides - Motorola WiNG 5.7.1 System Reference Manual

5.4.5.1 Radio Power Overrides

Device Overrides
Use the Power screen to set or override one of two power modes (3af or Auto) for an access point. When Automatic is selected,
the access point safely operates within available power. Once the power configuration is determined, the access point
configures its operating power characteristics based on its model and power configuration.
An access point uses a complex programmable logic device (CPLD). The CPLD determines proper supply sequencing, the
maximum power available and other status information. One of the primary functions of the CPLD is to determine the maximum
power budget. When an access point is powered on (or performing a cold reset), the CPLD determines the maximum power
provided by the POE device and the budget available to the access point. The CPLD also determines the access point hardware
SKU (model) and the number of radios. If the access point's POE resource cannot provide sufficient power to run the access
point (with all intended interfaces enabled), some of the following interfaces could be disabled or modified:
• The access point's transmit and receive algorithms could be negatively impacted
• The access point's transmit power could be reduced due to insufficient power
• The access point's WAN port configuration could be changed (either enabled or disabled)
To define an access point's power configuration or apply an override to an existing parameter:
1. Select the Configuration
2. Select Devices
3. Select Device
4. Select a target device from the device browser in the lower, left-hand, side of the UI.
5. Select Device Overrides
6. Select Power.
A screen displays where an access point's power configuration can be defined or overridden.
tab from the Web UI.
from the Configuration tab.
Overrides.
from the Device menu to expand it into sub-menu options.
NOTE: A blue override icon (to the left of a parameter) defines the parameter as having
an override applied. To remove an override, go to the Basic Configuration screen's
Device Overrides field and select
from the device.
Figure 5-144 Device Overrides - Power screen
Clear Overrides. This will remove all overrides
5 - 219