Motorola WiNG 5.7.1 System Reference Manual page 556

6 - 86 WiNG 5.7.1 Access Point System Reference Guide
Channel List
13. Select OK to update the Smart RF Channel and Power settings for this policy. Select
configuration. The Smart RF policy can be invoked at any point in the configuration process by selecting
RF Policy from the upper, left-hand side, of the access point user interface.
14. Select Scanning
be updated. Additionally, the Smart RF configuration cannot be applied to the access point profile unless this setting
remains selected.
NOTE: The monitoring and scanning parameters within the Scanning Configuration
screen are only enabled when Custom is selected as the Sensitivity setting from the
Basic Configuration screen.
15. Enable or disable
When enabled, detector radios monitor their coverage areas for potential failed peers or coverage area holes requiring
transmission adjustments for coverage compensation.
16. Set the following
Threshold
Index
Use the Select drop-down menu to select the channels used in Smart RF area based
channel settings.
Configuration. Ensure Activate SMART RF Policy
Figure 6-38 SMART RF - Scanning Configuration screen
Smart Monitoring Enable
OCS Monitoring Awareness Settings
Select this option and specify a threshold from 10 - 10,000. When the threshold is reached
awareness settings are overridden with the values specified in the table.
Select an Index value from 1 - 3 for awareness overrides. The overrides are executed
based on index, with the lowest index being executed first.
remains selected so the screen's parameters can
by selecting the option. The feature is enabled by default.
for the Smart RF policy:
Reset to revert to the last saved
Activate SMART