Motorola WiNG 5.7.1 System Reference Manual page 349

6. Use the Basic Settings
Enable PPPoE
Service
DSL Modem Network
(VLAN)
Client IP Address
7. Define the following Authentication
Username
Figure 5-171 Device Overrides - PPPoE screen
field to enable PPPoE and define a PPPoE client:
Select Enable PPPoE to support a high speed client mode point-to-point connection using
the PPPoE protocol. The default setting is disabled.
Enter the 128 character maximum PPPoE client service name provided by the service
provider.
Use the spinner control to set the PPPoE VLAN (client local network) connected to the DSL
modem. This is the local network connected to DSL modem. The available range is 1 -
4,094. The default VLAN is VLAN1.
Provide the numerical (non hostname) IP address of the PPPoE client.
parameters for PPPoE client interoperation:
Provide the 64 character maximum username used for authentication support by the
PPPoE client.
5 - 265