Motorola WiNG 5.7.1 System Reference Manual page 155

5. Set the following General Settings
Host Name
Router ID
UDP Listen Port
Tunnel Bridging
6. Set the following Logging Settings
Enable Logging
IP Address
Hostname
Router ID
Figure 5-40 Network - L2TPv3 screen - General tab
for an L2TPv3 profile configuration:
Define a 64 character maximum hostname to specify the name of the host that is sent tunnel
messages. Tunnel establishment involves exchanging 3 message types (SCCRQ, SCCRP and
SCCN) with the peer. Tunnel IDs and capabilities are exchanged during the tunnel
establishment with the host.
Set either the numeric IP address or the integer used as an identifier for tunnel AVP
messages. AVP messages assist in the identification of a tunnelled peer.
Select this option to set the port used for listening to incoming traffic. Select a port from
1,024 - 65,535. The default port is 1701.
Select this option to enable or disable bridge packets between two tunnel end points. This
setting is disabled by default.
for a L2TPv3 profile configuration:
Select this option to enable the logging of Ethernet frame events to and from bridge VLANs
and physical ports on a defined IP address, host or router ID. This setting is disabled by
default.
Optionally use a peer tunnel ID address to capture and log L2TPv3 events.
If not using an IP address for event logging, optionally use a peer tunnel hostname to capture
and log L2TPv3 events.
If not using an IP address or a hostname for event logging, use a router ID to capture and log
L2TPv3 events.
5 - 71