Table of Contents
Advertisement
20. Define or override the following
MLCP IP
MLCP IPv6
MLCP VLAN
Tunnel MiNT across
extended VLAN
21. Select the
Tunnel Controller Load Balancing (Level1)
22. Define the group name of clustered tunnel controllers in the
23. Use the
Re-elect Tunnel Controller for this AP
access point only.
24. Select
OK
to save the changes and overrides made to the Settings tab. Select
configuration.
25. Select the
IP
tab to display the link IP network address information shared by the devices managed by the MINT
configuration.
MINT Link
Settings:
Select this option to enable MINT Link Creation Protocol (MLCP) by IP Address. MINT
Link Creation Protocol is used to create one UDP/IP link from the device to a neighbor.
That neighboring device can be another AP.
Select this option to enable MINT Link Creation Protocol (MLCP) by IPv6 Address.
MLCP by IPv6 is used to create one UDP/IP link from the device to a neighbor. The
neighboring device does not need to be a Virtual Controller, it can be an standalone
access point.
Select this option to enable MLCP by VLAN. MLCP is used to create one VLAN link
from the device to a neighbor. That neighboring device can be another AP.
Select this option to enable tunneling MiNT protocol packets across extended VLANs.
option to enable load balancing on the tunnel controller.
button to re-elect a different tunnel controller. This is specific for this
Preferred Tunnel Controller Name
Reset
to revert to the last saved
5 - 375
field.
Hide quick links:
Advertisement
Table of Contents
