Table of Contents
Advertisement
5 - 62 WiNG 5.7.1 Access Point System Reference Guide
8. Configure the
rules) to apply to the PPPoE client connection. If a firewall rule does not exist suiting the data protection needs of the PPPoE
client connection, select the Create icon to define a new rule configuration or the Edit icon to modify an existing rule.
9. Select the
VPN Crypto Map
map configuration to this WWAN interface.
10. Use the
WWW Default Route Priority
11. Select
OK
to save the changes to the Advanced Settings screen. Select
5.2.5.5.1 WAN Backhaul Deployment Considerations
WAN Backhaul Configuration
Before defining a profile's WAN Backhaul configuration refer to the following deployment guidelines to ensure these
configuration are optimally effective:
• If the WAN card does not connect after a few minutes after a no shutdown, check the access point's syslog for a detected
ttyUSB0 No such file event. If this event has occurred, linux didn't detect the card. Re-seat the card.
• If the WAN card has difficulty connecting to an ISP (syslog shows that it retries LCP ConfReq for a long time), ensure the
SIM card is still valid and is plugged in correctly.
• If a modem doesn't responding with an OK during the dialing sequence, the WAN card is in an unknown state and will not
accept a command. Re-seat the card and begin the dialup sequence again until the card is recognized.
• If encountering a panic when conducting a hotplug, power off the access point for one minute. The access point could
continue to panic or detect the descriptor of the last utilized WAN card. Thus, it's a good idea to clear the panic state by
temporarily disconnecting then re-applying access point power.
• If wanting to unplug the WAN card, ensure sure you shutdown first, as the probability of getting a panic is reduced. With
the new high-speed WAN cards currently being utilized, the chances of getting a panic significantly increase.
IPv4 Inbound Firewall
Rules. Use the drop-down menu to select a firewall (set of IP access connection
to use with this WWAN configuration. Use the drop-down menu to apply an existing crypto
spinner to set a default route priority for this interface. The default value is 3000.
Reset
to revert to the last saved configuration.
Hide quick links:
Advertisement
Table of Contents
