Motorola WiNG 5.7.1 System Reference Manual page 414

5 - 330 WiNG 5.7.1 Access Point System Reference Guide
3. Define the following:
Tunnel Name
Tunnel Type
Interface
Traffic Selector (ACL)
4. Click the Next
Figure 5-217 VPN Step-By-Step Wizard - Step 1
Provide a name for the tunnel in the Tunnel Name field.
Select the tunnel type being created. Two types of tunnels can be created. Site to Site is used
to create a tunnel between two remote sites as indicated in the image. Remote Access is used
to create a tunnel between an user device and a network as indicated in the image.
Select the interface to use. Interface can be a Virtual LAN (VLAN) or WWAN or PPPoE
depending on the interfaces available on the device.
This field creates the Access Control List (ACL) that is used to control who uses the network.
Provide the Source and Destination IP address ranges with their net mask. Click the Add Rule
button to add the rule into the ACL.
button to go to Step 2.