Motorola WiNG 5.7.1 System Reference Manual page 382

5 - 298 WiNG 5.7.1 Access Point System Reference Guide
31. Set the following
periodically sent to hosts or sent in response to solicitation requests. The advertisement includes IPv6 prefixes and other
subnet and host information.
Accept RA
No Default Router
No MTU
No Hop Count
32. Select OK to save the changes to the basic configuration. Select
33. Select the IPv4
IPv4 is a connectionless protocol. It operates on a best effort delivery model that does not guarantee delivery or assures
proper sequencing or avoidance of duplicate delivery (unlike TCP).
Figure 5-193 Device Overrides - Network - OSPF Virtual Interfaces - Basic Configuration screen - IPv4 tab
Router Advertisement Processing
Enable this option to allow router advertisements over this virtual interface. IPv6 hosts can
configure themselves automatically when connected to an IPv6 network using the neighbor
discovery protocol via ICMPv6 router discovery messages. When first connected to a network,
a host sends a link-local router solicitation multicast request for its configuration parameters;
routers respond to such a request with a router advertisement packet that contains Internet
layer configuration parameters.This setting is enabled by default.
Select this option to consider routers unavailable on this interface for default router selection.
This setting is disabled by default.
Select this option to not use the existing MTU setting for router advertisements on this virtual
interface. If the value is set to zero no MTU options are sent. This setting is disabled by
default.
Select this option to not use the hop count advertisement setting for router advertisements
on this virtual interface. This setting is disabled by default.
tab to set IPv4 settings for this virtual interface.
settings for the virtual interface. Router advertisements are
Reset to revert to the last saved configuration.