Motorola WiNG 5.7.1 System Reference Manual page 876

13 - 60 WiNG 5.7.1 Access Point System Reference Guide
Fallback Enabled
Fallback Image
Triggered
Next Boot
The System Resources
Available Memory
(MB)
Total Memory (MB)
Currently Free RAM
Recommended Free
RAM
Current File
Descriptors
Maximum File
Descriptors
CPU Load 1 Minute
CPU Load 5 Minutes
CPU Load 15 Minutes
The Fan Speed
Number
Speed (Hz)
The Temperature
Number
Temperature
The Kernel Buffers
Buffer Size
Current Buffers
Maximum Buffers
Displays whether this option is enabled. This method enables a user to store a known legacy
version and a new version in device memory. The user can test the new software, and use an
automatic fallback, which loads the old version on the access point if the new version fails.
Displays whether the fallback image was triggered. The fallback image is an old version of a
known and operational software stored in device memory. This allows a user to test a new
version of software. If the new version fails, the user can use the old version of the software.
Designates this version as the version used the next time the access point is booted.
field displays the following:
Displays the available memory (in MB) available on the access point.
Displays the access point's total memory.
Displays the access point's free RAM space. If it is very low, free up some space by closing
some processes.
Displays the recommended RAM required for routine operation.
Displays the access point's current file descriptors.
Displays the access point's maximum file descriptors.
Lists this access point's CPU utilization over a 1 minute span.
Lists this access point's CPU utilization over a 5 minute span.
Lists this access point's CPU utilization over a 15 minute span.
field displays the following:
Displays the number of fans supported on the this access point.
Displays the fan speed in Hz.
field displays the following:
Displays the number of temperature elements used by the access point.
Displays the current temperature (in Celsius) to assess a potential access point overheat
condition.
field displays the following:
Lists the sequential buffer size.
Displays the current buffers available to the selected access point.
Lists the maximum buffers available to the selected access point.