Motorola WiNG 5.7.1 System Reference Manual page 461

Figure 5-252 Device Overrides - Advanced Profile MINT screen - IP (Add)
27. Set the following Link IP
IP
Port
Routing Level
Listening Link
Forced Link
Link Cost
Hello Packet Interval
Adjacency Hold Time
IPSec Secure
IPSec GW
parameters to complete the MINT network address configuration:
Define or override the IP address used by peer access points for interoperation when
supporting the MINT protocol.
To specify a custom port for MiNT links, select this option and use the spinner control
to define or override the port number from 1 - 65,535.
Use the spinner control to define or override a routing level of either 1 or 2.
Specify a listening link of either 0 or 1. UDP/IP links can be created by configuring a
matching pair of links, one on each end point. However, that is error prone and doesn't
scale. So UDP/IP links can also listen (in the TCP sense), and dynamically create
connected UDP/IP links when contacted.
Select this option to specify the MiNT link as a forced link. This setting is disabled by
default.
Use the spinner control to define or override a link cost from 1 - 10,000. The default
value is 100.
Set or override an interval in either Seconds (1 - 120) or Minutes (1 - 2) for the
transmission of hello packets. The default interval is 15 seconds.
Set or override a hold time interval in either Seconds (2 - 600) or Minutes
(1 - 10) for the transmission of hello packets. The default interval is 46 seconds.
Select this option to use a secure link for IPSec traffic. This setting is disabled by
default. When enabled, both the header and the traffic payload are encrypted.
Define either an IP address or hostname for the IPSec gateway. A valid hostname
cannot contain an underscore.
5 - 377