Motorola WiNG 5.7.1 System Reference Manual page 355

4. Select Network to expand its sub menu options.
5. Select L2TP V3.
NOTE: A blue override icon (to the left of a parameter) defines the parameter as having
an override applied. To remove an override, go to the Basic Configuration screen's Device
Overrides field and select
device.
Figure 5-174 Device Overrides - Network - L2TPv3 screen, General tab
6. Set the following General Settings
Host Name
Router ID
UDP Listen Port
Tunnel Bridging
Clear Overrides. This will remove all overrides from the
for an L2TPv3 profile configuration:
Define a 64 character maximum hostname to specify the name of the host that sent tunnel
messages. Tunnel establishment involves exchanging 3 message types (SCCRQ, SCCRP
and SCCN) with the peer. Tunnel IDs and capabilities are exchanged during the tunnel
establishment with the host.
Set either the numeric IP address or the integer used as an identifier for tunnel AVP
messages. AVP messages assist in the identification of a tunnelled peer.
Select this option to set the port used for listening to incoming traffic. Select a port from
1,024 - 65,535. The default port is 1701.
Select this option to enable or disable bridge packets between two tunnel end points. This
setting is disabled by default.
5 - 271