Motorola WiNG 5.7.1 System Reference Manual page 334

5 - 250 WiNG 5.7.1 Access Point System Reference Guide
Trust 802.1p COS values
Trust IP DSCP
15. Set the following
Trust ND Requests
Trust DHCPv6 Responses
ND Header Mismatch
Validation
RA Guard
16. Select OK to save the changes to the security configuration. Select Reset to revert to the last saved configuration.
17. Select the Spanning Tree
Select this option to enable 802.1p COS values on this port channel. The default value
is enabled.
Select this option to enable IP DSCP values on this port channel. The default value is
enabled.
IPv6 Settings:
Select this option to enable the trust of neighbor discovery requests required on an IPv6
network. This setting is disabled by default.
Select this option to enable the trust all DHCPv6 responses. DHCPv6 is a networking
protocol for configuring IPv6 hosts with IP addresses, IP prefixes or other configuration
attributes required on an IPv6 network. This setting is enabled by default.
Select this option to enable a mismatch check for the source MAC within the ND
header and Link Layer Option. This setting is disabled by default.
Select this option to enable router advertisements or ICMPv6 redirects from this
Ethernet port. This setting is disabled by default.
tab.
Figure 5-164 Port Channels - Spanning Tree tab