Profile Interface Override Configuration - Motorola WiNG 5.7.1 System Reference Manual

5 - 224 WiNG 5.7.1 Access Point System Reference Guide

5.4.5.3 Profile Interface Override Configuration

Device Overrides
An access point requires its Virtual Interface be configured for layer 3 (IP) access or layer 3 service on a VLAN. A virtual interface
defines which IP address is associated with each connected VLAN ID.
An interface configuration can have overrides applied to customize the configuration to a unique deployment objective. For
more information, refer to the following:
• Ethernet Port Override Configuration
• Virtual Interface Override Configuration
• Port Channel Override Configuration
• Radio Override Configuration
• WAN Backhaul Overrides
• PPPoE Configuration
5.4.5.3.1 Ethernet Port Override Configuration
Profile Interface Override Configuration
Use an Ethernet Port override to change (modify) parameters of an access point's Ethernet Port configuration.
The following ports are available on supported access point models:
• AP6511 - fe1, fe2, fe3, fe4, up1/POE (LAN)
• AP6521 - GE1/POE (LAN)
• AP6522/AP6522M - GE1/POE (LAN)
• AP6532 - GE1/POE (LAN)
• AP6562 - GE1/POE (LAN)
• AP7131 - GE1/POE (LAN), GE2 (WAN)
• AP7161 - GE1/POE (LAN), GE2 (WAN)
• AP7181 - GE1/POE (LAN), GE2 (WAN)
• AP7502 - GE1, fe1, fe2, fe3
• AP7522- GE1/POE (LAN)
• AP7532 - GE1/POE (LAN)
• AP7562 - GE1/POE (LAN), GE2 (WAN)
• AP8122/AP8132/AP8222/AP8232/AP8163 - GE1/POE (LAN), GE2 (WAN)
To define an Ethernet port configuration override:
1. Select the Configuration
2. Select Devices
3. Select Device
4. Select a target device from the device browser in the lower, left-hand, side of the UI.
5. Select Interface
tab from the Web UI.
from the Configuration tab.
Overrides.
to expand its sub menu options.