Table of Contents
Advertisement
3. Define the following Device Heartbeat Settings in respect to devices supported by the profile:
Designated IS Priority
Adjustment
4. Select the
Latency of Routing Recalculation
control used for defining a latency period from 0 - 60 seconds. The default setting has the option disabled.
5. Define the following MINT Link Settings in respect to devices supported by the profile:
MLCP IP
MLCP IPv6
MLCP VLAN
Tunnel MiNT across
extended VLAN
6. Select the
Tunnel Controller Load Balancing (Level1)
7. Define the group name for clustered tunnel controllers in the
8. Select
OK
to save the changes made to the
9. Select the
IP
tab to display the link IP network address information shared by the devices managed by the access point's
MINT configuration. The
time settings used by managed devices to securely communicate amongst one another within the IPSec network.
Figure 5-122 Advanced Profile Configuration - MINT Protocol screen - IP tab
10. Select
Add
to create a new Link IP configuration or
Use the spinner control to set a Designated IS Priority Adjustment setting from -255
and 255. This is the value added to the base level DIS priority to influence the
Designated IS (DIS) election. A value of +1 or greater increases DISiness. The default
setting is 0.
option (within the
Select this option to enable MINT Link Creation Protocol (MLCP) by IP Address. MLCP
by IP is used to create one UDP/IP link from the device to a neighbor. The neighboring
device does not need to be a Virtual Controller, it can be an standalone access point.
Select this option to enable MINT Link Creation Protocol (MLCP) by IPv6 Address.
MLCP by IPv6 is used to create one UDP/IP link from the device to a neighbor. The
neighboring device does not need to be a Virtual Controller, it can be an standalone
access point.
Select this option to enable MLCP by VLAN. MLCP by VLAN is used to create one
VLAN link from the device to a neighbor. The neighboring device does not need to be
a Virtual Controller, it can be an standalone access point.
Select this option to enable tunneling MiNT protocol packets across extended VLANs.
Settings
IP
tab displays the IP address, routing level, link cost, hello packet interval and adjacency hold
Edit
Shortest Path First (SPF)
option to enable load balancing on the tunnel controller.
Preferred Tunnel Controller Name
tab. Select
Reset
to revert to the last saved configuration.
to modify an existing MINT configuration.
5 - 187
field) to enable the spinner
field.
Hide quick links:
Advertisement
Table of Contents
