Table of Contents
Advertisement
6. Select
Save/Commit
the next page listed in the
NOTE: While you can navigate to any page in the navigation panel, you cannot complete
the Initial Setup Wizard until each task in the Navigation Panel has a green check mark.
The following sections describe the two different wizards and their parameters. The available wizards are:
•
Typical Setup Wizard
•
Advanced Setup Wizard
3.1.1 Typical Setup Wizard
Using the Initial Setup Wizard
The
Typical Setup
is the recommended wizard. This wizard uses default parameters for most of the configuration parameters
and creates a working network with the fewest steps.
The
Typical Setup
•
Network Topology Selection
•
LAN Configuration
•
WAN Configuration
•
Wireless LAN Setup
•
Summary And Commit Screen
To configure the access point using the
1. Select
Typical Setup
2. Select Next.
The Initial Setup Wizard displays the Access Point Settings screen to define the access point's Standalone versus Virtual
Controller AP functionality. This screen also enables selection of the country of operation for the access point.
within each page to save the updates made to that page's configuration. Select
Navigation
Panel. Select
wizard consists of the following:
Typical Setup
from the
Choose One type to Setup the Access Point
Back
to revert to the previous screen without saving your updates.
Wizard:
Next
to proceed to
field.
3 - 5
Hide quick links:
Advertisement
Table of Contents
