CHAPTER 23
Replacing Cooling System Component
Replacing the MX240 Air Filter
Removing the MX240 Air Filter
Copyright © 2016, Juniper Networks, Inc.
Replacing the MX240 Air Filter on page 259
Replacing the MX240 Fan Tray on page 261
Removing the MX240 Air Filter on page 259
1.
Installing the MX240 Air Filter on page 260
2.
CAUTION:
Do not run the router for more than a few minutes without the air
filter in place.
CAUTION:
Always keep the air filter in place while the router is operating,
except during replacement. Because the fans are very powerful, they could
pull small bits of wire or other materials into the router through the unfiltered
air intake. This could damage the router components.
To remove the air filter (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Loosen the captive screws on the air filter cover.
2.
Remove the air filter cover.
3.
Slide the air filter out of the chassis.
4.
Figure 111 on page
260):
259