Related
Documentation
Installing an MX240 SCB
Copyright © 2016, Juniper Networks, Inc.
Figure 105: Connecting DC Power to the Router
MX240 DC Power Supply Description on page 88
Removing an MX240 DC Normal-Capacity Power Supply on page 318
Preventing Electrostatic Discharge Damage to an MX240 Router on page 416
DC Power Wiring Sequence Warning for M Series, MX Series, and T Series Routers
DC Power Supply Electrical Specifications for the MX240 Router on page 143
To install an SCB (see
Figure 106 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Carefully align the sides of the SCB with the guides inside the chassis.
2.
Slide the SCB into the chassis until you feel resistance, carefully ensuring that it is
3.
correctly aligned.
Grasp both ejector handles, and rotate them simultaneously clockwise until the SCB
4.
is fully seated.
Place the ejector handles in the proper position, vertically and toward the center of
5.
the board.
Check the LEDs on the SCB faceplate to verify that it is functioning normally.
6.
Chapter 21: Installing Components
253):
251