Figure 142: Installing An As Mlc - Juniper mx240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
Related
Documentation
308
CAUTION: When the AS MLC is out of the chassis, do not hold it by the
ejector handles, bus bars, or edge connectors. They cannot support its
weight.
Slide the AS MLC all the way into the card cage until you feel resistance.
8.
Grasp both ejector handles, and rotate them clockwise simultaneously until the AS
9.
MLC is fully seated.
Use one of the following methods to bring the AS MLC online:
10.
Press and hold the AS MLC online/offline button until the green
button lights steadily, in about 5 seconds. The LEDs and online/offline button for
each AS MLC are located above it on the craft interface.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the
CAUTION: After the
removing the AS MLC again, removing an AS MLC from a different slot, or
inserting an AS MLC in a different slot.
You can also verify correct AS MLC and AS MSC or AS MXC functioning by issuing the
and
show chassis fpc show chassis fpc pic-status

Figure 142: Installing an AS MLC

Preventing Electrostatic Discharge Damage to an MX240 Router on page 416
Replacing an MX240 AS MSC on page 309
Replacing an MX240 AS MXC on page 311
LED lights steadily, wait at least 30 seconds before
OK
.
SC B
SC B
OK LED next to the
.
CLI Explorer
Copyright © 2016, Juniper Networks, Inc.