Lift - Juniper mx240 Hardware Manual
Universal edge router
Hide thumbs
Also See for mx240:
- Hardware manual (512 pages) ,
- Instruction for upgrading (35 pages) ,
- Quick start manual (31 pages)
Table of Contents
Advertisement
MX240 3D Universal Edge Router Hardware Guide
Reinstalling Components in the MX240 Router After Installing it without a Lift
Reinstalling the Power Supplies After Installing the MX240 Router without a Lift
188
Removing Components from the MX240 Router Before Installing it without a Lift on
page 181
Reinstalling Components in the MX240 Router After Installing it without a Lift on
page 188
After the router is installed in the rack, you reinstall the removed components before
booting and configuring the router. The following procedures describe how to reinstall
components in the chassis, first in the rear and then in the front:
1.
Reinstalling the Power Supplies After Installing the MX240 Router without a
Lift on page 188
Reinstalling the Fan Tray After Installing the MX240 Router without a Lift on page 189
2.
Reinstalling the SCBs After Installing the MX240 Router without a Lift on page 190
3.
Reinstalling the DPCs After Installing the MX240 Router without a Lift on page 190
4.
Reinstalling the FPCs After Installing the MX240 Router without a Lift on page 191
5.
Reinstall the rightmost power supply first and then work your way to the left. To reinstall
the AC or DC power supplies (see
the DC power supplies):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
For an AC-powered router, switch the AC input switch on the power supply to the
2.
off (
O
) position. For a DC-powered router, switch the circuit breaker on the power
supply to the off (
) position.
O
We recommend this even though the power supplies are not connected to power
sources.
Using both hands, slide the power supply straight into the chassis until the power
3.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate or blank installed in the power supply slot.
Tighten the captive screws.
4.
Figure 67 on page
189, which shows the installation of
Copyright © 2016, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
