Reinstalling the Fan Tray After Installing the MX240 Router without a Lift
Copyright © 2016, Juniper Networks, Inc.
Figure 67: Reinstalling a Power Supply
To reinstall the fan tray (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the fan tray on each side and insert it straight into the chassis. Note the correct
2.
orientation by the "this side up" label on the top surface of the fan tray.
Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
3.
Figure 68: Reinstalling a Fan Tray
Figure 68 on page
189):
Chapter 16: Installing the MX240 Router
189