Figure 124: Installing A Routing Engine In An Mx240 Router; Figure 125: Installing A Routing Engine In An Mx480 Router - Juniper mx240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
274
Connect the management device cables to the Routing Engine. After the Routing
6.
Engine is installed, the
Replace the former master Routing Engine, RE0, with the Routing Engine RE-S-X6-64G.
7.
NOTE: The Routing Engine RE-S-X6-64G is supported only on the SCBE2.
RE-S-X6-64G is not compatible with the SCB or the SCBE.
The Routing Engine might require several minutes to boot. After the Routing Engine boots,
verify that it is installed correctly by checking the
interface. If the router is operational and the Routing Engine is functioning properly, the
green LED on the Routing Engine lights steadily. If the red
ONLINE
Engine lights steadily instead, remove and install the Routing Engine again. If the red
LED still lights steadily, the Routing Engine is not functioning properly. Contact your
customer support representative.

Figure 124: Installing a Routing Engine in an MX240 Router

Figure 125: Installing a Routing Engine in an MX480 Router

LED starts blinking green slowly.
ONLINE
FAIL , RE0 , and RE1 LEDs on the craft
LED on the Routing
FAIL
Copyright © 2016, Juniper Networks, Inc.
FAIL